[SOLVED] Fixing U0121: Communication Lost With Abs Control Module (2024)

The automobile fault code U0121 indicates a problem with the Anti-Lock Brake System (ABS) Control Module. The most common symptom is the Engine Light ON or Service Engine Soon Warning Light.

The cause of this fault code could be a faulty ABS Control Module, an open or shorted ABS Control Module harness, or a poor electrical connection in the ABS Control Module circuit. The importance of repairing this issue lies in the fact that it affects the vehicle’s braking system.

The repair difficulty is moderate, and the repair time is estimated at 1.0 hour. To fix the issue, one should visually inspect the related wiring harness and connectors, check for damaged components, and look for broken, bent, pushed out, or corroded connector’s pins.

Decode U0121: Unveiling Symptoms Of A Faulty Vehicle

If you notice the Engine Light ON (or Service Engine Soon Warning Light), it could be a sign of u0121 fault code. Here are the symptoms to look out for:

• The automobile fault code U0121 can cause the following symptoms: Engine Light ON, Service Engine Soon Warning Light, loss of communication with the Anti-Lock Brake System (ABS) module, loss of communication with the Electronic Stability Control (ESC) module, loss of communication with the Traction Control Module (TCM), and loss of communication with the Powertrain Control Module (PCM).

Decoding U0121: Common Causes Of The Fault Code

The automobile fault code u0121 can be caused by a faulty ABS control module, open or shorted harness, or poor electrical connection.

• The automobile fault code u0121 can be caused by a faulty Anti-Lock Brake System (ABS) Control Module.
• It can also be caused by an open or shorted Anti-Lock Brake System Control Module harness.
• Additionally, a poor electrical connection in the Anti-Lock Brake System Control Module circuit can also trigger this fault code.

Fix U0121: Simple Steps To Solve The Fault Code

Below are some possible fixes for the automobile fault code u0121, including inspecting wiring harness and connectors for damage or corrosion.

• To fix the automobile fault code u0121, first, check the possible causes listed above.
• Then, visually inspect the related wiring harness and connectors.
• Look for any damaged components and check for broken, bent, pushed out, or corroded connector’s pins.
• This fix will take an estimated repair time of 1.0 hour.

Crunching The Numbers: U0121 Repair Cost & Complexity

The automobile fault code U0121 can be diagnosed and fixed within an estimated repair time of 1.0 hour.

The cost of repair is influenced by the hourly rate charged by the auto repair shop, which typically ranges between $75 and $150 per hour.

Therefore, the total cost of diagnosing and fixing the U0121 fault code will depend on the hourly rate charged by the auto repair shop and the estimated repair time required to fix the issue.

U0121: Lost Communication With Abs Module

The U0121 fault code indicates a communication problem with the Anti-Lock Brake System (ABS) Control Module.The ABS Control Module sends periodic messages to the Controller Area Network (CAN) bus.

If the CAN bus does not receive these messages, the U0121 code is set.

The CAN bus uses two wires for communication, CAN high and CAN low.

The U0121 code is not caused by inductive spikes, electrical fields, or other noise.The U0121 code can cause the ABS system to malfunction, leading to potential safety issues.If you receive the U0121 code, it is important to have it diagnosed and repaired by a qualified mechanic.

FAQ

Wrap Up

If your engine light is on and showing the u0121 code, it may be due to a faulty ABS control module or poor electrical connection.

To fix it, visually inspect the wiring harness and connectors for damage or corrosion.

Check for broken or bent pins.

Resources

• Resource 1
• Resource 2
• Resource 3
• Resource 4